Gefen EXT-HDKVM-LANTX Manual de usuario

Audio Embedder 3GSDI IPOverHDKVMRelease A8User ManualEXT-HDKVM-LAN

IPOverHDKVM 01 Getting StartedSender Unit Layout... 2Fro

page | 2Getting StartedFront ID Name Description1 Power This LED glows steady blue when the unit is connected to an AC outlet and the unit is

page | 3Getting StartedBack ID Name Description1 HDMI In Connect the included HDMI cable from this connector to the Hi-Def source.2 RS-232 Co

page | 4Front ID Name Description1 Power This LED glows steady blue when the unit is connected to an AC outlet and the unit is powered ON. 2

page | 5Getting StartedBack ID Name Description1 HDMI Out Connect an HDMI cable from this connector to the HDTV display.2 RS-232 Connect the

Page TitleGetting StartedThe HD KVM over IP Sender and Receiver units can either be connected over a Local Area Network (LAN) or they can be directly

page | 7Getting StartedInstallation4. See Supplementary Connections for instruction on connecting USB, IR, RS-232, and audio cables.5. Connect the i

page | 8Local Area Network (LAN) Connection In order to connect the HD KVM over IP to a Local Area Network (LAN), both the Sender and Receiver u

page | 96. Disconnect the cable between the Sender and Receiver unit.7. Connect the cable from the Sender unit to the network.

HD KVM over IPImportant Safety InstructionsiiGENERAL SAFETY INFORMATION 1. Read these instructions.2. Keep these instructions.3. Heed all warnings.

page | 10Getting StartedInstallationSupplementary Connections ► USB (see USB Control for more information on using USB devices)1. Connect a USB cable

page | 11Getting StartedSample Wiring DiagramInstallationEXT-HDKVM-LANCAT-5 CABLE (Up to 330 ft)HDMI CABLEUSB CABLEAUDIO CABLEMIC CABLERS-232 CABLERS-

IPOverHDKVM02 Operating the HD KVM over IPBasic Operation ...

page | 14Displaying the IP AddressIf the IP address(es) of a Sender and/or Receiver unit are not known, then use the following procedure to display th

page | 15 3. After a few moments, the screen will go blank and the IP address of both the Sender and Receiver unit will be displayed in the lower-ri

page | 16Operating the HD KVM over IP5. To upgrade the rmware to a limited number of channels, refer to Upgrading the Firmware for more information.

page | 17Setting the IP ModeThe HD KVM over IP can be set to Auto IP, DHCP, or Static IP mode. By default, the HD KVM over IP is shipped in Auto IP m

page | 18Setting the Video ChannelIn order a Sender and Receiver unit to communicate with one another, they must both be set to the same channel. Thi

page | 19Enabling or Disabling Video over IPThis feature is useful for masking video. Disabling the video on the Sender unit will mask the video on a

HD KVM over IPWarranty InformationGefen warrants the equipment it manufactures to be free from defects in material and workmanship.If equipment fails

page | 20Operating the HD KVM over IPBasic OperationI/O Setup ► HDCPNOTE: Some computers will enable HDCP if an HDCP-compliant display is detected.

page | 21Operating the HD KVM over IPConguring Unicast ModeThe term unicast is used to describe a conguration where information is sent from one poi

page | 223. Click the Unicast button under the Network Mode group. When selected, the Unicast button will be highlighted in blue. 4. Click

page | 23Switching between Sender units in Unicast modeWhen multiple Sender and Receiver unit are used in unicast mode, the HD KVM over IP behaves as

page | 24Operating the HD KVM over IPFigure 2.3 - Unicast mode: Receiver unit R1 is now connected to Sender unit S1.Note that each of the Sender units

page | 25Operating the HD KVM over IPIn order to solve the problem, in Figure 2.4, we would need to make sure that each of the Sender units is set to

page | 26Conguring Multicast ModeThe term multicast is used to describe a conguration where information is sent from one or more points to a set of

page | 273. Click the Multicast button under the Network Mode group. When selected, the Multicast button will be highlighted in blue. 4. C

ivHD KVM over IPGefen, LLC c/o Customer Service 20600 Nordhoff St. Chatsworth, CA 91311Telephone: (818) 772-9100 (800) 545-6900Fax: (818)

vHD KVM over IP• The HD KVM over IP is compatible with the DVI KVM over IP and the VGA KVM over IP, which allows these products to be connected withi

viOperating NotesVideo over IPUDP / MC3344 A Xcontrol channelTCP3344 A Xcontrol channelTCP3240 A XTCP unicast mode onlyUDPX D 3245UDP unicast mode onl

viiFeatures• Supported HDMI Features ► HDCP ► 12-bit Deep Color ► LPCM 7.1 audio, Dolby® TrueHD, Dolby Digital® Plus, and DTS-HD® Master Audio™ ► Lip

3GSDI Audio EmbedderHD KVM over IPTable of Contentsviii01 Getting StartedSender Unit Layout.....

HD KVM over IPTable of Contents03 AppendixUpgrading the Firmware .....................