Gefen EXT-WUSB Manual de usuario

Wireless USB 2.0 ExtenderUSER MANUALwww.gefen.com

VIEWING AND CHANGING THE 802.11g RADIO CHANNELThe following instructions are for advanced users only.These instructions should only be executed if spe

The Wireless USB 2.0 Extender can operate on one of three 802.11g radio channels. Each radio channel broadcasts data in a different frequency band wi

VIEWING CHANGING THE 802.11g RADIO CHANNEL (CONT...)85.6.7.8.Once the desired 802.11g Radio Channel is displayed, press and hold the Pair/CH button fo

The following instructions are for advanced users only.PAIRING A WIRELESS USB 2.0 SENDER AND RECEIVER9These instructions should only be executed if sp

PAIRING A WIRELESS USB 2.0 SENDER AND RECEIVER (CONT...)104.5.6.Wait for the LED’s on the Wireless USB 2.0 Sender unit and the Wireless USB 2.0 Receiv

MAINTENANCE & TROUBLESHOOTING11Symptoms/Cause RemedyLink LEDs on Wireless USB 2.0 Sender unit and Wireless USB 2.0 Receiver unit are off.Cause: Th

MAINTENANCE & TROUBLESHOOTING (CONT...)12Symptoms/Cause RemedyLink LED on Wireless USB 2.0 Sender unit is on;Host LED on Wireless USB 2.0 Sender u

13MAINTENANCE & TROUBLESHOOTING (CONT...)Symptoms/Cause RemedyA device is connected to Wireless USB 2.0 Receiver unit and the corresponding Device

14MAINTENANCE & TROUBLESHOOTING (CONT...)Symptoms/Cause RemedyAll LEDs on both the Wireless USB 2.0 Sender unit and Wireless USB 2.0 Receiver unit

15Radio Max Data Rate 54Mbps (802.11g)USB device support High-speed devices (480 Mb/s)Full speed devices (12 Mb/s)Low speed devices (1.5 Mb/s)USB host

ASKING FOR ASSISTANCETechnical Support:Telephone (818) 772-9100 (800) 545-6900Fax (818) 772-9120Technical Support Hours:8:00am to 5:00pmMonday t

Gefen Inc. warrants the equipment it manufactures to be free from defects in material and workmanship. If equipment fails because of such def

TABLE OF CONTENTS Introduction How It Works Panel Layout Before You Begin / Connecting Wireless USB Hub / Establishing Wireless Communication Chec

This manual explains the installation and operation of the Wireless USB 2.0 Extender. The instructions in this guide assume a general knowledge of com

HOW IT WORKSThe Wireless USB 2.0 Sender unit is connected to the computer or USB source.The USB 2.0 peripherals are connected to the Wireless USB 2.0

WIRELESS USB 2.0 EXTENDER SENDER PANEL LAYOUT 3Power, Link, Host, and Activity LED IndicatorsIR Eye5v Power SupplyPair/CHButtonUSB INPower, Link, Host

WIRELESS USB 2.0 EXTENDER RECEIVER PANEL LAYOUT USB OutLED IndicatorsIR Eye

CONNECTING THE WIRELESS HUB1.2.3.4.5.6.7.8.Place the sender unit near the host computer.Plug the Type-B connector on the USB cable (included) into the

5CHECKING THE INSTALLATIONOnce the Activity LED’s on the Wireless USB 2.0 Sender unit and Wireless USB 2.0 1.2.3.4.Check that the Power LED’s on the W