Gefen 4x4 HDMI 1.3 Matrix Manual de usuario

®4x4 Matrix forHDMI® 1.3EXT-HDMI1.3-444User Manualwww.gefen.com

7EDID MODESEDID. What is it and what is it used for?Under normal circumstances, an source device (digital and analog) will require information about a

8The RMT-16IR remote control will allow the user to select which source will be routed to which output. Each of the 4 outputs are assigned a group of

94X4 MATRIX FOR HDMI 1.3 REMOTE INSTALLATIONRMT-16IRRear PanelBattery ChamberDIP SwitchesInstalling the IR Remote Control Battery1. Remove the batter

10Follow these steps to place the 4x4 Matrix for HDMI 1.3 into IR channel setup mode.1. Remove the power cable from the rear side of the 4x4 Matrix f

11Binary TableASCII Corresponding RMT16-IRButtonBinary ASCII CorrespondingRMT16-IRButtonBinary1 1 0011 0001 9 9 0011 10012 2 0011 0010 a 10 0110 00013

12Video Amplifi er Bandwidth ... 225 MHzInput Video Signal ...

13WARRANTYGefen warrants the equipment it manufactures to be free from defects in material and workmanship.If equipment fails because of such defects

Rev A5PbThis product uses UL listed power supplies.20600 Nordhoff St., Chatsworth CA 913111-800-545-6900 818-772-9100 fax: 818-772-9120www.gefen

ASKING FOR ASSISTANCERev A5Technical Support:Telephone (818) 772-9100 (800) 545-6900Fax (818) 772-9120Technical Support Hours:8:00 AM to 5:00 PM

CONTENTS1 Introduction2 Operation Notes3 Features4 Panel Layout5 Panel Descriptions6 Connecting And Operating The 4x4 Matrix for HDMI 1.37 EDID Modes

1Congratulations on your purchase of the 4x4 Matrix for HDMI 1.3. Your complete satisfaction is very important to us.GefenGefen delivers innovative, p

2READ THESE NOTES BEFORE INSTALLING OROPERATING THE 4X4 MATRIX FOR HDMI 1.3• You should connect all the cables and power supply prior to connecting p

3Supported HDMI 1.3 Features:• 225 MHz (up to 12 bit YUV 444 @ 1080p)• Deep Color• Dolby TrueHD and DTS-HD Master Audio• Lip SyncFeatures:• Route a

4Front PanelBack Panel1067 8 9531 2PANEL LAYOUT4

51 IR (Infrared) ReceiverThis receiver will accept command for switching between HDMI input devices using the included RMT-16IR remote control.2 Pow

6How to Connect the 4x4 Matrix for HDMI 1.31. Connect up to 4 HDMI source devices to the 4x4 Matrix for HDMI 1.3 using the included HDMI cables.NOTE: